If you're like most homeowners, their own lawn is to cut, you will probably find that you first go to your mower will start in spring, the time to start is much more difficult than it is for the rest of lawn mowing season. Perhaps you are frustrated with him, you forget that you are no longer a teenager, and throw your back out of the pull-start giving an angry snap. Then perhaps you are thinking of you "I wish I had one of those lawn mowers electric start". If you have e-starterMowers, perhaps thinking. "Man, what with the electric starter has, and it still looks' dead, thank God I'm not one of those hand-start models."
Start the time you've tried your mower for a few minutes, you've probably tried some with the accelerator, and then maybe your neighbor is "useful" came and said that it is probably flooded the engine. Maybe you can try a couple of times with the throttle open a little 'and kill. If you have aHand-start the machine, we can consider the bill next chiropractic, and ask yourself if the attitude of the neighbor boy to mow the lawn may not be a bad idea.
So why is it so hard, an engine that has been inactive for six months to start? If you look at the candle under the microscope, one can understand the problem. If you see the top of the candle to the naked eye, may look good, but if you replace the plug with a new brandclean, dry spark plug, you'll probably find that your lawn will probably start in a few seconds.
The key to the mystery lies in something at the microscopic level of the ceramic insulator place on the surface of a candle, over time in a car that is stored outside. As the temperature and relative humidity cycles, day after day, are condensed over time, micro-droplets evaporate from the surface of your ceramic candle. Every time these micro-dropletsForm, assign them the tiny carbon particles on your spark plugs the last time you ran the engine were deposited. The growth of the droplets to form pushes the particles together in conducting paths, wind up providing an alternate path for electricity (ceramic insulator on the surface rather than through the radio link), when you start the mower.
The carbon particles are very short things, but they offer a path whose electricalThe resistance is low enough so that no spark or the spark so little energy that do not ignite the charge in the cylinder. Once the engine starts, the heat of combustion within the calendar year, explains this problem in a few minutes, so if you start the engine again in the next few weeks to go, starts well.
A simple solution to this initial startup is to replace the spark plug. Of course, if you are a cheaper solution that does not require a trip to be stored in, I have afor you, and comes in the form of a hot flame. A propane torch works best, but if you do not need to do so, a practical, lighters and a gas stove to do. You see, there's a reason that the ceramic around the center electrode of the spark plug of material is done is done. The surface properties of the material effectively catalyzes the combustion of carbon deposits when the ceramic hot enough. Of course, if your mower is not yetstarted, but nothing has that "warm enough."
To resolve this problem, remove the spark plug from the mower, and prepare for a clean, hot flame (using a propane torch or a gas lighter or a gas burner on the stove). Clinging to the end of the candle, which usually connects itself with the glue line, the other end (the end of the spark) in the candle flame for a few seconds when you turn the candle a couple of times, heating the center electrode ceramics and the surrounding area.It only takes a few seconds. After you take the spark from the fire, take a look at the ceramic around the center electrode.
It should be noted that the ceramic around the center electrode of the bright white candle hours, where previously he could be his dirty white or gray. Now is your candle is like new. Put it back in your lawn, and enjoy, as soon roars to life!
0 comments:
Post a Comment